Honda Accord 2008 Manual page 678

07/11/02 09:17:59 61TA0000_110_0359
13. Disconnect the quick-connect fitting (A): Hold the
connector (B) with one hand, and squeeze the
retainer tabs (C) with the other hand to release
them from the locking tabs (D). Pull the connector
off.
NOTE:
• Be careful not to damage the line (E) or other
parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it comes off easily.
• Do not remove the retainer from the line; once
removed, the retainer must be replaced with a
new one.
＊０４
14. After disconnecting the quick-connect fitting, check
it for dirt or damage (see step 5 on page 11-368).
15. Do the battery terminal reconnection procedure
(see page 22-89).
D
C
A
B
Without the HDS
1. Remove the driver's dashboard lower cover
(see page 20-152).
2. Remove PGM-FI main relay 2 (FUEL PUMP) (A)
from the driver's under-dash fuse/relay box.
A
3. Start the engine, and let it idle until it stalls.
NOTE: If any DTCs are stored, clear and ignore
E
them.
4. Turn the ignition switch to LOCK (0).
5. Remove the fuel fill cap to relieve the pressure in
the fuel tank.
6. Do the battery terminal disconnection procedure
(see page 22-89).
＊０５
(cont'd)
11-359