Inserting / Changing The Memory Card - Honeywell ACS-8 Installation Instructions Manual

Installation Instructions / ACS-8
9.7.2 Inserting / changing memory card
Caution! Data loss possible!
Never insert or remove the memory card while the ACS 2plus is powered up!
If the memory card is removed, all of the ACS-2plus data is irrevocably lost.
Danger of data loss / disruption in operation!
All data will be lost if the device is set to dead-voltage and the battery is removed. Data must
be reloaded to the controller via the AC-software function "Load data". According to the
amount of data, this procedure may vary in length of time. During this time the concerned
doors are without any function.
Procedure:
1. Switch the ACS-8 off.
2. Disconnect the CPU
board from the power
supply (remove the
lithium battery, dis-
connect the battery
and any emergency
power supplies).
3. Observe antistatic
precautions before
removing the memory
card from the antistatic
bag.
4. Grip the memory card
by its sides and avoid
touching the connec-
tors.
5. Insert the memory
card. The slot is in the
middle of the board.
6. Secure it with the 4
screws provided.
7. Bootstrap the device
according to descrip-
tion on page 69 (table
3 and 4).
8. If the basic settings
have been done via the
setup (see chapter
11.1 varant 2), the
setup must be re-
peated.
9. Run "Load data /
parameterization" for
t h e c o r r e s p o n d i n g
controller in the AC-
software.
Memory extension slot
69