Defining The Controller In Netedit; Leds, Buzzer And Cancel Buzzer Push-Button - Honeywell ACS-8 Installation Instructions Manual

86
11.2 Defining the controller in IQ NetEdit
After hardware installation (mounting and wiring the controllers) and setting the hardware parameters
(controller address, baud rate, protocol) using the DIP switches or the ACS-8 setup, the devices must then
be defined in the access control software.
(See also chapter 9.6 = DIP switches and the corresponding documents of the used interface cards).
Transferring the hardware configuration to the access control software is done by a special configuration
program which is part of the access control software. Detailed examples how to configer an ACS-8 controller
can be found in the manual of the configuration software.

12. LEDs, buzzer and cancel buzzer push-button

The LEDs, the buzzer and the cancel buzzer push-button are located on the LED board in the housing cover.
For differentiation of the controller types ACS-2plus and ACS-8, the ACS-8 from firmware 7.00 on activates
all LEDs and the buzzer while booting.
The functions of the individual LEDs are explained in the following.
The buzzer stop push-button makes it possible to reset the buzzer manually. To do so, press the push-button
at least for 3 seconds with a suitable object.
Installation Instructions / ACS-8