Honeywell ACS-8 Installation Instructions Manual page 61

Installation Instructions / ACS-8
Table 2: Protocol and Baud rate
6 7 Function
0 0 Setup via terminal program
0 0 Ethernet interface card, encrypted
(Item no. 026840.30) Configuration
mode (Description see
documentation P55213-10-xxx)
0 1 9-Bit-Protocol = factory setting
1 0 DIN-66090-Protocol
1 1 RDT-Protocol
0 = OFF
1 = ON
Table 3: Service-Function
8 Function
0
Factory setting (service function not active... switch positions 1 - 7 according to table 1 and 2)
1
Service function (switches 1 - 7 see table 4)
Warning!
Table 4: functions with the service switch activated
1 2 3 4
1 1 1 1
If the switch 8 ON state is detected, LED 1 on the CPU board flashes green until the next reset is carried
out.
The flashing green LED indicates that a function is in process. When this LED lights permanently, the
function has been completed
Procedure of bootstrapping:
1. Set all DIP switches to ON
2. Reset (reset push-button)
3. LED 1 flashes (wait)
4. LED 1 lights permanently
5. Switch DIP S1 to the required
position (baud-rate, address,
protocol, etc.)
6. Reset (reset push-button)
Switch 8 is reserved for service level functions and should not be changed
from the factory setting of OFF. Changing the switch setting may cause loss
of data.
Do not change factory settings!
5 6 7 8 Function
1 1 1 1
Bootstrap
Connected to
e. g. Event protocol (for
ethernet)
RS 232 (ST1, socket)
Interface converter
COMx / X-Port / X-Port Pro
Modem
ISDN card
61
Comment
Switch positions 1-7
OFF
Switch positions 1-5
ON
With these protocols,
the baud rate is fixed
set at 19200.