Honeywell ACS-8 Installation Instructions Manual page 85

Installation Instructions / ACS-8
Settings for network connection using the Ethernet interface card:
Conditions for operation:
1.
2.
- Event-protocol
- Baud rate 19200
- MVA (virtual address of the current controller to be found in NetEdit).
- DVA (virtual destination address of the workstation to which the controller communicates
= MVA of the corresponding workstation to be found in NetEdit).
If either DIP switch 6 or 7 of switch block S1 are ON, then the DIP switch settings take
priority over the software. An information warning message will appear on affected options
in the program that are disabled by these switches.
Example: 1. 9-bit-ZK/ZE prot.
2. DIN prot.:
3.=>RDT prot.
4. Event prot.
Status: Addr: 32; 19200 bauds
*** Defined by DIP-Switch! ***
Press <Enter>...
When using the interface of the ACS-8 controller for RDT, the interface is found to be
already in use by the RDT protocol.
Procedure: - Disconnect the RDT cable from the ACS-8
- Connect the "setup" cable
- Carry out the boot login
85