Acs-8-Setup - Honeywell ACS-8 Installation Instructions Manual

Installation Instructions / ACS-8
11. Commissioning
During commissioning of the ACS-8, the following steps must be carried out:
1. The back-up battery must be inserted (see chapter 9.5).
2. Connection to the mains.
3. Reset using the S1 DIP switch (see chapter 9.6.1, table 4).The ACS-8 is reset to the initial state.
4. Checking or setting the necessary parameters using DIP switches or the ACS-8 setup.
5. Set the controllers in NetEdit / IQ NetEdit (see chapter 11.2 and installation manual NetEdit / IQ
MultiAccess).
6. Reset the controller using the MultiAccess for Windows / IQ MultiAccess software (see user manual
MultiAccess for Windows part B, chapters 5 and 6) and/or IQ NetEdit / IQ MultiAccess.
11.1 ACS-8 setup
The ACS-8 is delivered with the factory settings (see factory settings in the following or in the appendix).
This state must be checked and changed if necessary. This can be carried out in two ways...
Option 1:
Option 2:
Please refer to the table in the appendix with the factory settings. These are valid after
setting and resetting the controller.
Setting using the S1 DIP switch (see chapter 9.6)
Procedure: 1. Setting the protocol
2. Setting the baud rate
3. Setting the address
The DIP switch settings are limited (as described in the tables in chapter 9.6).
ACS 8 setup using option 2 allows access to more setup features than are available with
the DIP switches.
Setting using ACS-8 setup
General description: The ACS-8 setup allows the current settings of the ACS-8 to be
checked and to edited. Changes can also be carried out during
normal use of the system without impeding operation.
The number of parameters that can be modified depends on the
DIP switch setting of the S1 switch block.
77