Honeywell ACS-8 Installation Instructions Manual page 87

Installation Instructions / ACS-8
Functions of the LEDs and the buzzer of ACS-8 and module bus participants
LED/buzzer
Normal (green)
Fault (yellow)
Tamper (red)
Alarm (red)*
Alert (red)*
Buzzer
The cancel buzzer push-button makes it possible to reset the buzzer manually. To do so, press the push-
button at least for 3 seconds with a suitable object.
* Not available at module bus participants (door module, input module, output module, in/output module).
Meaning of the LEDs of AC readers
LED colour
yellow
yellow
yellow
green
red
green
red
red
Additionally, the key and LED functions of the macro control of IQ MultiAccess are valid (see separate
manual "Supplementary Functions of IQ MultiAccess", P32205-46-0G0-xx).
3
Except potetial separation module. There the LEDs indicate the communication between ACS-8 and module
bus participants.
For details see mounting and connection instaructions of potential separation module, P32508-10-002-xx.
State Meaning
Off No operating voltage
Slow flashing Not parameterized
Fast flashing Parameterization running
On Ready
Off No fault
On Battery/battery fault
Line failure
Central reset
Off No tamper
On Tamper
Off No alarm
On Number of incorrect attempts
Unauthorized opening or door was open too
long
Off No message
On Threat
Off No message or manually reset
Fast interval Tamper/alarm
On Line/battery/battery failure
Basic state After reading a data carrier
on
off
flashing
on
on
on
on
flashing
3
Without storing
(except for central reset)
With storing
With storing
With storing
With storing
Without storing
Meaning
Ready to read
- Device is dead voltage
- Controller is not parapeterized
- PIN- or door code entry is active
Reader is not allocated to any door
Permanent release
Permantent blocked
Door release
ID card not authorized
Read error
87