Honeywell ACS-8 Installation Instructions Manual page 81

Installation Instructions / ACS-8
The individual menu items:
General
1. Communication:
Currently, only option 1 To Host is available. The parameters used by the ACS-8 for communication
with the host can be checked and edited. The current protocol is marked with "=>". Other current
values are shown in the Status line.
The last line is the dialogue line. Different entries are allowed depending on the cursor
position. (Uses both upper and lower case letters.) When entering a character that is not
allowed or when pressing the Enter key on its own, no modification is carried out. In this
case, the program skips back to the next higher level (max. the main menu).
Erroneous entries can be deleted by individual characters using the backspace key.
To delete the character buffer press the backspace key at least 3 times.
ACS-8 resetting:
Normally, the APPL.-Login is sufficient.
Advantages: Normal operation is not affected.
Login does not need to be carried out within the
3 second time limit during reset.
Some DIP switch settings have priority and do not permit any
changes to some settings of Communication - To Host
(see Dependencies later in this chapter). The message "Defined
by DIP-Switch" displays if changes are attempted to these
settings.
All peripheral devices connected to the affected ACS-8
are out of operation (the doors are closed) during
BOOT-Login until the setup area is exited.
Label: Shows the designation of the current ACS-8.
Example: [<no-name...>] = no name was assigned.
If the controller already exists in NetEdit the assigned designation
is shown under Label:.
Important: Use only unique designations!
either Interrupt the power supply
momentarily (pull the power
c o n n e c t o r , d e a c t i v a t e t h e
emergency power supply if
necessary).
or Press the reset button
81