Honeywell ACS-8 Installation Instructions Manual page 78

78
Requirements:
Procedure:
Laptop/notebook
Terminal program (e.g. Hyperterminal, Telemate, etc.)
9-pole serial cable (socket – socket)
Cable assignment:
Set switches 1 – 8 of DIP switch S1 to position OFF or 0

1 2 3 4
0 0 0 0
Press the reset button or momentarily disconnect the

controller from the mains.
Connect one of the serial interfaces of the notebook to the

ST1 serial interface of the ACS-8 (see 16.1).
Start the terminal program, e.g. Hyperterminal Start –

Programs - Accessories - (communication with Windows
2000) - Hyperterminal
Enter a unique name (e.g. ACS-8 setup) for New

Connection and select the corresponding icon. Confirm
with OK.
Installation Instructions / ACS-8
5 6 7 8 Function
0 0 0 0 Setup via Hyperterminal