Install Sim Card; Equipment Required - Honeywell Thor VM1 User Manual

Install SIM Card

A SIM card may be required for WWAN.
Note: The SIM card is not hot-swappable. After installing or removing a SIM card, the Thor VM1
must be rebooted for the change to take effect.

Equipment Required

The following equipment is user-supplied:
•
•
•
1. For convenience, the Thor VM1
2. If the Thor VM1 remains in the
3. Shutdown the Thor VM1.
4. Place the Thor VM1 face down on a
5. Using a #2 Phillips bit loosen the
6. Locate the SIM card installation slot, as highlighted to the right.
7. Slide the SIM card into the slot.
Note: The entire SIM slot is not visible due to the design of the Thor VM1 case. However, the
entire slot is shown below to help with installation.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
SIM card for desired carrier
Torquing tool capable of measuring inch pounds
#2 Phillips screwdriver bit
can be removed from the dock,
though it is not necessary.
dock, disconnect the power cable
from the dock.
stable surface.
M3 screws and then remove the
tethered access panel with the SIM
label. This panel is on the right
hand side when the Thor VM1 is face down with the top away from the user.
SIM
115