Install Sim Card; Equipment Required; Installation Procedure - Honeywell THOR VM1 User Manual

Install SIM Card

A SIM card may be required for WWAN.
Note: The SIM card is not hot-swappable. After installing or removing a SIM card, the Thor VM1 must be rebooted for the change
to take effect.

Equipment Required

The following equipment is user-supplied:
• SIM card for desired carrier
• Torquing tool capable of measuring inch pounds
• #2 Phillips screwdriver bit

Installation Procedure

1. For convenience, the Thor VM1 can be removed
from the dock, though it is not necessary.
2. If the Thor VM1 remains in the dock, disconnect the
power cable from the dock.
3. Shutdown the Thor VM1.
4. Place the Thor VM1 face down on a stable surface.
5. Using a #2 Phillips bit loosen the M3 screws and
then remove the tethered access panel with the
SIM label. This panel is on the right hand side when
the Thor VM1 is face down with the top away from
the user.
6. Locate the SIM card installation slot, as highlighted to the right.
7. Slide the SIM card into the slot.
Note: The entire SIM slot is not visible due to the design of the Thor VM1 case. However, the
entire slot is shown below to help with installation.
8. Do not force the SIM into the slot. The SIM slot is not a "spring lock" holder. When the SIM card is
fully inserted, it will trip the SIM detect switch as indicated by the arrow below. The access panel
has a tab that holds the SIM card in place.
SIM
9. Reattach the access panel, torquing the screws to 4-5 inch pounds.
10. If the SIM card is not detected, contact
11. If removed, reinstall the Thor VM1 in the dock.
12. Restart the Thor VM1.
4 - 62
SIM
Technical Assistance (page 9-1) for troubleshooting.