Honeywell Thor VM1 User Manual page 150

The mobile Bluetooth scanner / imager requires this information before discovering,
pairing, connecting or disconnecting can occur.
Important: The Thor VM1 Bluetooth address identifier label should remain protected
from damage (rips, tears, spills, soiling, erasure, etc.) at all times. It may be required
when pairing, connecting, and disconnecting new Bluetooth bar code readers.
Thor VM1 with Label
If the Thor VM1 has a Bluetooth address bar code label attached, follow these steps:
1. Scan the Bluetooth address bar code label, attached to the Thor VM1, with the Blue-
2. If this is the first time the Bluetooth scanner has scanned the Thor VM1 Bluetooth
3. Open the EZPair panel (
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu
6. Select Pair as Scanner to pair the Thor VM1 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps
and an LED flashes. Refer to the following section titled
Indications.
Note: After scanning the Thor VM1 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth device, the devices are currently paired.
Thor VM1 without Label
If the Thor VM1 Bluetooth address bar code label does not exist, follow these steps to
create a unique Bluetooth address bar code for the Thor VM1:
First, locate the Thor VM1 Bluetooth address by tapping
Bluetooth > About tab.
Next, create a Bluetooth address bar code label for the Thor VM1.
The format for the bar code label is as follows:
140
tooth mobile scanner.
label, the devices are paired. See section titled
If the devices do not pair successfully, go to the next step.
appears.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Bluetooth Beep and LED
(Start) > Control Panel > Bluetooth).
Indications.
Bluetooth Beep and LED
(Start) > Control Panel >