Honeywell Thor VM1 User Manual page 39

If the Thor VM1 is Full On, a press of the power button can be configured to put the unit
in Standby. See the
StandbyMode
When the standby timer expires without a primary event occurring, the Thor VM1 transi-
tions to Standby mode. Pressing the power button exits Standby mode and transitions
the Thor VM1 to Full On.
When in Standby mode, the status LED:
•
•
System Standby Wakeup Events
The following event transitions the Thor VM1 from Standby to Full On Mode:
•
Hibernate Mode
When the Thor VM1 enters hibernate mode, all LEDs are off. Pressing the power button
returns the Thor VM1 to Full On.
When in Hibernate Mode, the status LED:
•
•
System Hibernate Wakeup Events
The following event transitions the Thor VM1 from Hibernate to Full On Mode:
•
Off Mode
By default, the Thor VM1 turns off if the user presses the power button when the Thor
VM1 is On. This behavior can be configured on the
panel.
By default, pressing the power button shuts down the Thor VM1. This behavior can be
modified. See
The Thor VM1 is also off when it is not connected to a power source and the UPS battery
is depleted. However, an internal Real Time Clock (RTC) powered by an internal battery
maintains the date and time while the Thor VM1 is off.
Thor VM1 with Microsoft Windows Embedded Standard 2009 User Guide
Advanced
blinks green very slowly if external power is attached.
is off if external power is not attached.
Pressing and releasing the power button
blinks green very slowly if external power is attached.
is off if external power is not attached.
Pressing and releasing the power button.
Configure Power Button
tab of the Power control panel.
Behavior.
Advanced tab of the Power control
29