Table of Contents
Advertisement
LANSRLU1
WIN-PAK 2.0/Pro/Intl. R3 Configuration with UDS100
1.
Be sure all devices are properly
configured and attached over the
network.
2.
Log into the WIN-PAK 2/Pro
User Interface.
3.
On the WIN-PAK Menu Bar, go
to Configuration > Device >
Device Map.
4.
Assuming the 485 Loop has
already been configured, right-
click on the 485 and select Con-
figure.
5.
Notice two tabs, Basic Informa-
tion and Port Settings. Select the
Port Settings tab.
10
Honeywell Access Systems
6.
Under Port, press the drop down
arrow and select TCP/IP connec-
tion.
7.
At this point, enter an IP Address
or Node name.
8.
After the IP Address has been
entered, exit the Loop Configura-
tion by selecting OK.
9.
At this point, continue with the
system programming.
10.
Upon completion of program-
ming, test communication by Ini-
tializing the panel(s).
7-101002-00
Hide quick links:
Advertisement
Table of Contents
