Enabling Ancp On An Ethernet Interface - Cisco 10000 Series Configuration Manual

Configuring Access-Network Control Protocol

Enabling ANCP on an Ethernet Interface

Use the following procedure to enable ANCP on an Ethernet interfaces.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface type number
Example:
Router(config)# interface FastEthernet1/0/0
Step 4
ip address address mask
Example:
Router(config-if)# ip address 10.16.1.2
255.255.0.0
Step 5
interface type number.subinterface
Example:
Router(config-if)# interface
FastEthernet1/0/0.1
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
1-6
enable
configure terminal
interface type number
ip address address mask
interface type number.subinterface
encapsulation dot1q [vlanid] [second-dot1q second-vlanid]
ancp enable
ancp adjacency timer interval
Chapter 1
Purpose
Enables privileged EXEC mode. If prompted, enter your
password.
Enters global configuration mode.
Creates or modifies an interface. Enters interface
configuration mode.
Assigns an IP address and subnet mask to the interface.
Creates or modifies a subinterface. Enters subinterface
configuration mode.
Access-Network Control Protocol
OL-14660-03