Cisco 10000 Series Configuration Manual page 142

debug ancp
debug ancp
To enable the display of debugging information related to ANCP, use the debug ancp command in
privileged EXEC mode. To disable debugging output, use the no form of this command.
You can use the debug condition interface to conditionalize all the debug commands where the ANCP
Note
TCP connections are terminated.
Syntax Description detail
errors
events
neighbor
packets
brief
Command Default Disabled
Command Modes Privileged EXEC
Command History Release
12.2(28)ZV
12.2(31)ZV1
Examples The following example enables debugging of ANCP errors:
Router# debug ancp details
ANCP details debugging is on
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-10
debug ancp {detail | errors | events | neighbor | packets [brief]}
no debug ancp {detail | errors | events | neighbor | packets [brief]}
Displays detailed static configuration information relating to ANCP and
displays dynamic line conditions.
Displays information about ANCP protocol errors.
Displays information about ANCP protocol events.
Displays information about ANCP neighbors.
Displays information about ANCP control packets.
(Optional) Displays static configuration information for ANCP control
packets.
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
This command was modified for Access Network Control Protocol (ANCP),
replacing L2CP.
Chapter A ANCP Command Reference
OL-14660-03