Cisco 10000 Series Configuration Manual page 153

Chapter A ANCP Command Reference
show ancp status
To view ANCP status information for ANCP endpoints configured on a broadband remote access server
(BRAS) interface, use the show ancp status command in privileged EXEC mode.
Syntax Description interface
Command Default
Status information about ANCP appears for all interfaces configured on the BRAS.
Command Modes Privileged EXEC
Command History Release
12.2(28)ZV
12.2(31)ZV1
Examples
The following example shows the status information that appears when you enter the show ancp status
command for a specific interface:
Router# show ancp status GigabitEthernet1/0/0
ANCP enabled on the following interfaces
GigabitEthernet1/0/0
ANCP endpoint(s) on this interface:
ANCP stateESTAB
Neighbor 10.0.0.1
Neighbor port11005
Hello interval100
Sender instance1
Sender name6363218A
Send port0
Partition ID0
TCB21289B00
Related Commands Command
show ancp neighbor
OL-14660-03
show ancp status interface
The type and number of an interface.
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
This command was modified for Access Network Control Protocol (ANCP),
replacing L2CP.
Description
Displays information about ANCP and port mappings between the ANCP
access node neighbor (DSLAM) and the broadband remote access server
(BRAS), and shows dynamic line conditions.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
show ancp status
A-21