Advanced Configuration And Modification Of The Management Ethernet Interface - Cisco 6000 Series Configuration Manual

Advanced Configuration and Modification of the
Management Ethernet Interface
This module describes the configuration of Management Ethernet interfaces.
Before you can use Telnet to access the router through the LAN IP address, you must set up a Management
Ethernet interface and enable Telnet servers, as described in the Configuring General Router Features module
of the System Setup and Software Installation Guide for Cisco NCS 6000 Series Routers . This module describes
how to modify the default configuration of the Management Ethernet interface after it has been configured,
as described in System Setup and Software Installation Guide for Cisco NCS 6000 Series Routers.
Note
Forwarding between physical layer interface modules (PLIM) ports and Management Ethernet interface ports
is disabled by default. To enable forwarding between PLIM ports and Management Ethernet interface ports,
use the rp mgmtethernet forwarding command.
Note Although the Management Ethernet interfaces on the system are present by default, the user must configure
these interfaces to use them for accessing the router, using protocols and applications such as Simple Network
Management Protocol (SNMP), Common Object Request Broker Architecture (CORBA), HTTP, extensible
markup language (XML), TFTP, Telnet, and command-line interface (CLI).
Feature History for Configuring Management Ethernet Interfaces
Release Modification
Release 5.0.0 This feature was introduced.
• Prerequisites for Configuring Management Ethernet Interfaces, on page 12
• Information About Configuring Management Ethernet Interfaces, on page 12
• How to Perform Advanced Management Ethernet Interface Configuration, on page 13
• Configuration Examples for Management Ethernet Interfaces, on page 19
• Additional References, on page 20
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
3
C H A P T E R
11