Configuring Access-Network Control Protocol - Cisco 10000 Series Configuration Manual

Chapter 1 Access-Network Control Protocol
http://www.ietf.org/internet-drafts/draft-wadhwa-gsmp-l2control-configuration-00.txt
2.
3.

Configuring Access-Network Control Protocol

To configure Access-Network Control Protocol (ANCP), perform the following global or subinterface
configuration tasks:
•
•
•
•
OL-14660-03
If GSMP determines that it must resynchronize the adjacency, it restarts the adjacency
c.
synchronization process, which includes the capability negotiation defined in the ANCP
extension draft available at:
In an ANCP, if a neighbor (neighbor1) contains capabilities that its neighbor (neighbor2) does not
support, neighbor1 turns off the capabilities and recommunicates the packets to neighbor2 with the
same set of capabilities as neighbor2.
After both the neighbors agree to the same set of capabilities, adjacency is established.
Enabling ANCP on an Ethernet Interface, page 1-6
Enabling ANCP on an ATM Interface, page 1-7
Mapping DSLAM Ports to VLAN Interfaces on Broadband Remote Access Servers, page 1-8
Mapping DSLAM Ports to PVC Interfaces on Broadband Remote Access Servers, page 1-9
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Configuring Access-Network Control Protocol
1-5