Qos Parameterized Actions - Cisco 10000 Series Configuration Manual

Parameterized Actions
Table 5-2 Parameterized Actions for a Service Policy (continued)
MQC QoS Action
sg-service-group
service-group-name
sg-service-type {primary |
secondary}

QoS Parameterized Actions

Table 5-3
When the router processes a QoS parameterized VSA, it sets the omitted policy actions as the action's
default value. Valid values for all action parameters are equivalent to the valid ranges and types
supported in the corresponding MQC command.
Table 5-3 QoS Parameterized Policy Actions
MQC QoS Action
bandwidth kbps-bandwidth
bandwidth percent percentage
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
5-10
RADIUS Attribute
sg-service-group sg_svc_grp
sg-service-type sg_svc_type
lists the QoS policy actions supported for parameterization of QoS services.
RADIUS Attribute
bw-abs(bw-in-kbps)
bw-rpct(pct)
Chapter 5 Dynamic Service Policy Modifications
Description
Associates an Intelligent Service Gateway (ISG)
service with a service group.
service-group-name or sg_svc_grp is the name of the
service group.
Identifies an Intelligent Service Gateway (ISG)
service as primary or secondary.
primary identifies the service as a primary service,
which is a service that contains a network-forwarding
policy.
secondary identifies the service as a secondary
service, which is a service that does not contain a
network-forwarding policy. This level of service is
the default.
sg-svc_type is a primary or secondary service.
Description
Specifies or modifies the bandwidth allocated for a
class belonging to a policy-map.
kbps-bandwidth or bw-in-kbps specifies the amount
of bandwidth, in kilobits per second (kbps), to be
assigned to the class.
Specifies or modifies the amount of unused
bandwidth allocated for a class belonging to a
policy-map.
percentage or pct is the amount of guaranteed
bandwidth, based on a relative percent of available
bandwidth. Valid values are from 1 to 100.
OL-14660-03