Cisco 10000 Series Configuration Manual page 163

Chapter A ANCP Command Reference
Router# show atm pvc interface atm3/0/0.6 100/1000 vaccess
InterfaceNameVPI VCITypeInterface
ATM3/0/0.63100 1000pppoeVi3.1
The following example shows sample output when using the show atm pvc interface atm
interface-number vpi/vci vaccess detail command. The output is similar to the output that appears when
you use the show interface virtual-access-number command.
Router# show atm pvc interface atm3/0/0.6 100/1000 vaccess detail
ATM3/0/0.6: VCD: 3 VPI: 100 VCI: 1000
Virtual-Access3.1 is up, line protocol is up
Hardware is Virtual Access interface
Internet address will be negotiated using IPCP
MTU 1492 bytes, BW 599040 Kbit, DLY 100000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP Open
Stopped: IPCP
PPPoE vaccess, cloned from Virtual-Template1
Vaccess status 0x0
PPPoE Bound to ATM3/0/0.6 VCD: 3, VPI: 100, VCI: 1000
Keepalive set (10 sec)
3 packets input, 50 bytes
3 packets output, 44 bytes
Last clearing of "show interface" counters never
Related Commands Command
show atm svc
show atm vc
OL-14660-03
VCD / ProtocolVirtual Access
Description
Displays all ATM switched virtual circuits (SVCs) and traffic information.
Displays all ATM permanent virtual circuits (PVCs) and switched virtual
circuits (SVCs) and traffic information.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
show atm pvc
A-31