Configuring Multiservice Activation Using Access-Accept Messages; Enabling Multiservice Activation On The Router - Cisco 10000 Series Configuration Manual

Chapter 3 Dynamic Multiservice Activation and Deactivation
vsa cisco generic 250 string
"Aqos:vc-qos-policy-out=IPOne_out;qos:vc-qos-policy-in=IPOne_in"

Configuring Multiservice Activation Using Access-Accept Messages

To activate multiple services using RADIUS Access-Accept messages, perform the following
procedures:
•
•

Enabling Multiservice Activation on the Router

Use the following procedure to configure the ISG to accept multiple service activation.
SUMMARY STEPS
1.
2.
3.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
subscriber service multiple-accept
Example:
Router(config)# subscriber service
multiple-accept
Configuration Example for Enabling Multiservice Activation on the Router
The following sample configuration shows how to enable multiservice activation for RADIUS
Access-Accept messages:
ip dhcp class MY_DHCP
!
ip cef
!
!
subscriber service multiple-accept
OL-14660-03
Enabling Multiservice Activation on the Router, page 3-3
Configuring RADIUS for Service Activation and Deactivation, page 3-4
enable
configure terminal
subscriber service multiple-accept
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Multiservice Activation in an Access-Accept Message
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Enables multiple service activation on the router.
3-3