Enabling Atm Overhead Accounting In A Hierarchical Policy - Cisco 10000 Series Configuration Manual

Layer 2 Overhead Accounting

Enabling ATM Overhead Accounting in a Hierarchical Policy

Use the following procedure to enable ATM overhead accounting in a hierarchical policy.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
DETAILED STEPS
Command
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
policy-map policy-map-name
Example:
Router(config)# policy-map child
Step 4
class class-map-name
Example:
Router(config-pmap)# class data-premium
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
7-4
enable
configure terminal
policy-map policy-map-name
class class-map-name
bandwidth {bandwidth-kbps | percentage | remaining percentage} account {qinq | dot1q |
user-defined offset} aal5 subscriber-encap
exit
policy-map policy-map-name
class class-default
shape [average] mean-rate [burst-size] [excess-burst-size] [account {qinq | dot1q | user-defined
offset} aal5 subscriber-encap]
service-policy policy-map-name
exit
exit
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters global configuration mode.
Creates or modifies the child policy. Enters policy-map
configuration mode.
policy-map-name is the name of the child policy map. The
name can be a maximum of 40 alphanumeric characters.
Assigns the traffic class you specify to the policy map.
Enters policy-map class configuration mode.
class-map-name is the name of a previously configured
class map.
Chapter 7 Traffic Accounting
OL-14660-03