8-Port 10 Gigabit Ethernet Interface Module (8X10Ge) - Cisco ASR 903 Installation Manual

8-port 10 Gigabit Ethernet Interface Module (8x10GE)

8-port 10 Gigabit Ethernet Interface Module (8x10GE)
Figure 19: 8-port 10 Gigabit Ethernet Interface Module
The high density 8-port 10 Gigabit Ethernet interface module supports eight 10 Gigabit Ethernet ports using
SFP+ transceivers cages on the faceplate.
Note
It does not support XFP transceivers on the ports.
The 8-port 10 Gigabit Ethernet interface module is supported in slot 0 on the router with the A900-RSP3C-200-S
RSP module. Only 6 ports of the 8 are enabled. The ports enabled are 0, 1, 4, 5, 6, and 7.
Use the hw-module subslot command to enable the interface module in slot 0 of the router. Save the
configuration and reload the router to activate the interface module.
To remove the configuration, use no hw-module subslot command.
For information on supported SFP modules, see
Sheet.
For more information about installing a 8x10GE module, see the
8-Port 1 Gigabit Ethernet SFP with 1-Port 10 Gigabit Ethernet Combination Interface Module
The 8-port 1 Gigabit Ethernet SFP interface module with the 1-port 10 Gigabit Ethernet interface module is
a high density combination interface module. This module supports 8 Gigabit Ethernet SFP ports and 1 10
Gigabit Ethernet SFP+ port.
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
26
Cisco ASR 900 Series Aggregation Services Routers Data
Interface Module
Overview
Installation.