Cisco 10000 Series Configuration Manual page 53

Chapter 4 Redirecting Subscriber Traffic Using Intelligent Service Gateway Layer 4 Redirect
6.
7.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface type number
Example:
Router(config)# interface fastethernet 0/0.505
Step 4
ip subscriber
Example:
Router(config-if)# ip subscriber
Step 5
identifier interface
Example:
Router(config-subscriber)# identifier interface
Step 6
exit
Example:
Router(config-subscriber)# exit
Step 7
redirect to {group server-group-name | ip
ip-address [port port-number]} [duration
seconds] [frequency seconds]
Example:
Router(config-if)# redirect to group
advt-server duration 30 frequency 3600
OL-14660-03
exit
redirect to {group server-group-name | ip ip-address [port port-number]} [duration seconds]
[frequency seconds]
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Purpose
Enables privileged EXEC mode. If prompted, enter your
password.
Enters global configuration mode.
Specifies an interface and enters interface configuration
mode.
(Optional) Enables ISG IP subscriber configuration mode.
(Optional) Creates an ISG IP interface session.
Returns to interface configuration mode.
Redirects specified traffic to a specified server or server
group.
Configuring ISG Layer 4 Redirection
4-5