Cisco 10000 Series Configuration Manual page 137

Chapter A ANCP Command Reference
ancp atm shaper
To enable ANCP cell tax accounting for ATM U-interface connections, use the ancp atm shaper
command in global configuration mode. To disable ANCP cell tax accounting, use the no form of this
command.
Syntax Description
percent-factor
factor
Command Default
Disabled
Command Modes
Global
Command History Release
12.2(28)ZV
12.2(31)ZV1
Usage Guidelines The router checks the ancp dsl-type to enable adjustment to the downstream shaping rate.
If ATM is specified in the client-ID, the router looks for dsl-type 1, 2, 3 before the router applies the
shaper.
OL-14660-03
ancp atm shaper percent-factor factor
no ancp atm shaper percent-factor factor
Keyword that indicates to adjust the selected downstream shaping rate by
multiplying it by the specified factor.
The percentage by which the selected downstream shaping rate is multiplied.
Valid values are from 1 to 100.
The resulting shaping rate is applied to the terminating interface for
subscriber links.
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
This command was modified for Access Network Control Protocol (ANCP),
replacing L2CP.
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
ancp atm shaper
A-5