Show Ancp Session Event - Cisco 10000 Series Configuration Manual

Chapter 2 ANCP Enhancement for Ethernet OAM

show ancp session event

This command provides a snapshot of the last ANCP session event on each port of all neighbors.
Syntax Description
client-ID
Access-Loop-Circuit ID
Command Default Show all sessions.
Command Modes Global configuration.
Command History Release
12.2(28)ZV2
Examples
The following example shows sample output that appears when you enter the show ancp event port
client-ID "Access-Loop-Circuit-ID" command:
Local/Remote
Socket
------------------------- ---------- ------- -------------------------
12.12.2.2(6068)
12.12.1.1(11032)/
Last ANCP Port event received: Message len 144
Ver/Sub
Message Type
Result/Code
Partition ID
Transaction ID
I/SubMessage Number
Length
Port
Port Session Number
Event Sequence Number x0
Label 1
Label 2
Reserved
Message Type
Tech Type
Block Length
# of TLVs
Extension Block Lengt x00
Extensions
OL-14660-03
show ancp session event [client-ID "Access-Loop-Circuit-ID"]
When this optional parameter is specified, only information related to the
port appears. The "Access-Loop-Circuit-ID" is a unique ID that the
DSLAM sends to the BRAS for each unique port.
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
Interface
Gi1/0.1
x31
80 (80 Port Up 81 Port Down 82 Invalid Label 83 New Port
0 (1 NoSuccessAck 2 AckAll 3 Success 4 Failure 5 More
x00
x000000
x00 (x80 I)
144
x0
x0
x0
x0
x00
80 (See Message Type above)
5 (5 DSL)
0
2
(1 Access-Loop-Circuit-ID
2/3 Access-Aggregation-Circuit-ID-Binary/ASCII
4 DSL Line Attributes)
TLV Type 1 Len 2
TLV Type 4 Len 32
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
State Local/Remote
MAC Address
ESTAB 0006.52a5.141c/
0006.52a5.1c1c
84 Dead Port 85 Adjacency Update)
6 ReturnReceipt
show ancp session event
2-9