Cisco 10000 Series Configuration Manual page 149

Chapter A ANCP Command Reference
No data for type SYSTEM
No data for type RM CALL
No data for type RM VPDN
No data for type AUTH PROXY
No data for type IPSEC-TUNNEL
No data for type RESOURCE
No data for type 10
No data for type CALL
Debg: No data available
Radi: 641AACAC
Interface:
TTY Num = -1
Stop Received = 0
Byte/Packet Counts till Call Start:
Start Bytes In = 106
Start Paks
Byte/Packet Counts till Service Up:
Pre Bytes In = 192
Pre Paks
Cumulative Byte/Packet Counts :
Bytes In = 6264
Paks
StartTime = 19:56:01 PST Dec 17 2003
AuthenTime = 19:56:04 PST Dec 17 2003
Component = PPoE
Authen: service=PPP type=CHAP method=RADIUS
Kerb: No data available
Meth: No data available
Preauth: No Preauth data.
General:
Unique Id = 00000003
Session Id = 00000003
Attribute List:
63CCF180 0 00000001 port-type(156) 4 PPP over Ethernet
63CCF194 0 00000009 interface(152) 7 0/0/0/0
PerU: No data available
Table 0-1
Table 0-1
Field
EXEC
NET
CMD
Pre Bytes In
Pre Bytes Out
Pre Paks In
Pre Paks Out
Bytes In
OL-14660-03
Start Bytes Out = 168
In = 3 Start Paks
Pre Bytes Out = 258
In = 10 Pre Paks
Bytes Out = 6330
In = 444 Paks Out = 447
lists the significant fields shown.
show aaa user Field Descriptions
Description
Exec-Accounting database
Network Accounting database
Command Accounting database
Bytes that were received before the call was
authenticated
Bytes that were transmitted before the call was
authenticated
Packets that were received before the call was
authenticated
Packets that were transmitted before the call was
authenticated
Bytes that were received after the call was
authenticated
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
Out = 4
Out = 13
show aaa user
A-17