Ping Ancp - Cisco 10000 Series Configuration Manual

ping ancp

ping ancp
To trigger an on-demand local loop test on a DSLAM port, enter the following command:
Syntax Description interface interface
name neighbor-name
client-ID "client-ID"
count 1-32
timeout 0-255secs
opaque ulong number
ulong number
Command Modes Global configuration.
Command History Release
12.2(28)ZV2
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
2-4
ping ancp {interface interface | name neighbor-name} client-ID "client-ID" count 1-32 [timeout
0-255secs] [opaque ulong number ulong number]
Name of the interface to ping.
Name of the neighbor device to ping.
Access-Loop Circuit-ID for a particular port on the DSLAM.
Number of loopback messages that should be generated on the local loop.
Amount of time in seconds that the BRAS choose to timeout the ping
request. An amount of 0 means the BRAS waits indefinitely for a
DSLAM-sent port management response.
This is a pair of ulong numbers that the BRAS can choose to uniquely
identity each ping request, in addition to using client-ID.
Modification
This command was introduced and implemented on the Cisco 10000 series
router.
Chapter 2 ANCP Enhancement for Ethernet OAM
OL-14660-03