Cisco 10000 Series Configuration Manual page 74

Parameterized Actions
Table 5-3 QoS Parameterized Policy Actions (continued)
MQC QoS Action
queue-limit number-of-packets
set cos cos-value
set dscp dscp-value
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
5-12
RADIUS Attribute
queue-limit(packets-val)
set-cos(cos-val)
set-ip-dscp(dscp-val)
Chapter 5 Dynamic Service Policy Modifications
Description
Specifies or modifies the maximum number of
packets the queue can hold for a class policy
configured in a policy-map.
number-of-packets or packets-val is the number of
packets. Valid values are:
• PRE1—A number from 32 to 16384. The
number must be a power of 2. If the number
you specify is not a power of 2, the router
converts the number to the nearest power of 2
value.
PRE2—(Cisco IOS Release 12.2(16)BX and
•
later releases) A number from 32 to 16384. The
number does not need to be a power of 2.
• PRE2—(Cisco IOS Release 12.3(7)XI and
later releases) If the interface speed is less than
500 MB, packets-val is a number from 8 to
4096; the number must be a power of 2. If the
interface speed is greater than 500 MB,
number-of-packets is a number from 128 to
64000 and must be a power of 2. If it is not a
power of 2, the router converts the number to
the nearest power of 2 value.
Sets the Layer 2 class of service (CoS) value of an
outgoing packet.
cos-value or cos-val specifies an IEEE 802.1Q CoS
value from 0 to 7.
Marks a packet by setting the differentiated
services code point (DSCP) value in the type of
service (ToS) byte.
dscp-value or dscp-val is a number from 0 to 63 that
sets the DSCP value. The following reserved
keywords can be specified instead of numeric
values:
• EF (expedited forwarding)
• AF11 (assured forwarding class AF11)
AF12 (assured forwarding class AF12)
•
OL-14660-03