Cisco 10000 Series Configuration Manual page 158

show atm pvc
Table 0-2
Table 0-2
Field
Interface
VCD/Name
VPI
VCI
Type
Encaps
Peak
or
PeakRate
Avg/Min
or
Average Rate
Burst Cells
Sts or Status
Connection Name
UBR, UBR+, or
VBR–NRT
etype
Cisco 10000 Series Router Access Network Control Protocol Configuration Guide
A-26
describes the significant fields.
show atm pvc Field Descriptions
Description
Interface and subinterface slot and port.
Virtual connection descriptor (virtual connection number). The connection
name is displayed if a name for the VC was configured using the pvc command.
Virtual path identifier.
Virtual channel identifier.
Type of PVC detected from PVC discovery; either PVC-D, PVC-L, or PVC-M:
• PVC-D—PVC created as a result of PVC discovery.
• PVC-L—The corresponding peer of this PVC could not be found on the
switch.
PVC-M—Some or all of the QoS
•
those of the corresponding peer on the switch.
Type of ATM adaptation layer (AAL) and encapsulation.
Kilobits per second sent at the peak rate.
Kilobits per second sent at the average rate.
Maximum number of ATM cells that the VC can send at peak rate.
Status of the VC connection:
UP—The connection is enabled for data traffic.
•
DOWN—The connection is not ready for data traffic. When the Status
•
field is DOWN, a State field is shown. See a description of the different
values for the State field later in this table.
• INACTIVE—The interface is down.
Name of the PVC.
UBR—Unspecified bit rate QoS is specified for this PVC. See the ubr
•
command for further information.
UBR+—Unspecified bit rate QoS is specified for this PVC. See the ubr+
•
command for further information.
VBR–NRT—Variable bit rate–non-real-time QoS rates are specified for
•
this PVC. See the vbr-nrt command for further information.
Encapsulation type.
Chapter A ANCP Command Reference
1
parameters of this PVC fail to match
OL-14660-03