Honeywell PM23c User Manual page 96

Chapter 5 – Troubleshoot the Printer
86
Maintenance and Error Alerts (continued)
Error Alert
Out of Ribbon
Out of Media
Ribbon Low
Media Low
Ribbon Installed
Printer in Pause
Mode
Printer in Menu
Mode
Application Break
Print Job Complete
Odometer (Printer)
Odometer
(Printhead)
Odometer (User
Resettable)
Printhead Too Hot
Printhead Not
Detected
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Solution
Load ribbon in the printer.
Load media in the printer.
The diameter of the remaining roll of media is
lower than the specified value in the Ribbon Low
Diameter setting. Replace the ribbon.
The diameter of the remaining roll of media is
lower than the specified value in the Media Low
Diameter setting. Replace the media.
The printer is configured as a direct thermal
printer and thermal transfer ribbon is installed.
Remove the ribbon or configure the printer for
thermal transfer media.
A print job is paused from the front panel. Press
the Print button to resume printing.
A user entered a menu from the front panel. Press
the Home button to return to the Ready screen.
Fingerprint only. An application breaks
uncontrolled.
A print job has been successfully completed.
The printer has reached a limit set in the
Odometer (Printer) setting in Maintenance Alerts
for the amount of media to print before being
alerted.
The printhead has reached a limit set in the
Odometer (Printhead) setting in Maintenance
Alerts for the amount of media to print before
being alerted.
The printer has reached a limit set in the
Odometer (User Resettable) setting in
Maintenance Alerts for the amount of media
printed since the last reset.
The printhead is overheated and needs to cool
down. Wait for printing to resume automatically.
The printer is not detecting the printhead. Check
to make sure the printhead is installed and that the
printhead cable is firmly connected to the
printhead.