Table of Contents
Advertisement
Chapter 1 – About the Printer
About DSim
About Smart Printing
How to Set the Printer Command Language
Set the Command Language from the Printer Web
Page
18
DSim (DPL command language simulator) interprets Datamax™ data
streams without requiring any host programming changes. If you are
sending DPL label files to the printer, select DSim as your printer
command language. For more information, see the
Reference.
Smart Printing refers to the ability of the printer to independently run
printing operations without being connected to a host computer. If you are
running printer-based applications written in C#, select Smart Printing as
your printer command language.
For help creating Smart Printing applications, go to the Intermec
Developer Center at www.intermec.com/developer.
You can use one of these methods to change the printer command
language:
•
Printer Web page
•
Main Menu
•
PrintSet 5. For more information, see the PrintSet 5 online help.
To set the command language from the printer web page, you need to
turn on the printer and connect to your Ethernet or Wi-Fi network.
1 Make sure that the printer has media and ribbon (if necessary)
installed.
2 On your PC, open a browser.
3 In the Location or Address bar, type the printer IP address and press
Enter. The printer web page appears.
4 Click Login. The Login page appears.
5 Type your Username and Password and click Login. The default
username is itadmin and the default password is pass.
6 Click the Configure tab.
PM23c, PM43, and PM43c Mid-Range Printer User Manual
DSim Command
Advertisement
Table of Contents
