Table of Contents
Advertisement
Chapter 4 – Configure the Printer
How to Configure the Printer with Programming
Commands
How to Configure the Printer with SmartSystems
Configure the Printer with Touchless Configuration
66
You can change configuration settings by sending programming
commands directly from your PC to the printer through a terminal
program (such as HyperTerminal), a serial connection, or a network
connection.
If your printer uses the Fingerprint programming language, use the
SETUP GET command followed by the node, subnode, and parameter
setting. For example, here is a Fingerprint example that changes your
media setting to labels with gaps:
SETUP GET "MEDIA,MEDIA TYPE,LABEL (W GAPS)"
You must log in as an itadmin to perform a SET operation, but you do not
need to log in to perform a GET operation.
If your printer uses the IPL programming language, this example changes
your media setting to labels with gaps:
<STX><SI>T1<ETX>
For more information on how to change configuration settings with a
programming language, see either the
Reference
or the
IPL Command
You can use SmartSystems to change configuration settings on your
printer. The printer ships with the SmartSystems client loaded on it. The
console is part of SmartSystems and is available from the Intermec
website. To download SmartSystems, go to
products/smrtsysfoundation/index.aspx.
You can use touchless configuration to configure a printer without turning
it on or while it is in the box. If you have the touchless configuration option
installed in your printer, an RFID tag receives and stores data from an
external IP30 RFID reader and configures the settings when the printer is
turned on. The air protocol supported is EPCGlobal Class 1 Gen 2. The
available programmable memory is 384 bytes of USER memory bank.
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Fingerprint Command
Reference.
www.intermec.com/
Advertisement
Table of Contents
