Table of Contents
Advertisement
Chapter 2 – Set Up the Printer
About RFID Tag Position
Run the RFID Calibration Wizard
40
Tag Position, also referred to as TAGADJUST, specifies the distance (in
dots/mm/in) to move the label to align the tag with the RFID antenna.
Positive values move the label forward, and negative values move the
label back.
Use one of these methods to calculate Tag Position:
•
Run the RFID wizard.
•
Manually calculate the Tag Position.
Run the RFID calibration wizard to determine the best Tag Position and
Output Power (UHF inlays, only) for RFID media.
Note: After you determine the correct RFID media settings, you can save
these settings to a printer profile and load the profile when you need to
print on the specific RFID media.
1 Make sure the media type and media length are properly configured.
2 From the Main Menu, select Wizard > Calibration > RFID
Calibration.
3 To enable the RFID module, select Enable.
4 Load the RFID media.
5 Select OK.
When the calibration is complete, the printer displays the RFID Tag
Position and Output Power (UHF inlays, only).
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Advertisement
Table of Contents
