Honeywell PM23c User Manual page 146

Appendix B – Default Settings
136
Media Settings (continued)
Setting Description
Clip Default Determines if the printer prints items
outside the printable area of the label.
When this is set to Off, the printer returns
an error if any part of a bar code label
cannot be printed because that part
extends beyond the printable area. When
this is set to On, the printer prints all bar
code labels, but may also print
unreadable, incomplete labels.
Start Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative
value) before printing a label. Unit of
measurement is defined in the Unit of
Measure parameter. Range is -9999 to
+9999.
Stop Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative
value) after printing a label. Unit of
measurement is defined in the Unit of
Measure parameter. Range is -9999 to
+9999.
Media Selects the mode the printer uses to
Calibration calibrate media. Use Slow if the printer
Mode has trouble identifying gaps or marks in
media.
Length (Slow If Media Calibration Mode is set to Slow,
Mode) the printer prints the media length plus 10
mm. This value sets an additional amount
of media to be printed. Unit of
measurement is defined in the Unit of
Measurement parameter. Range is 0 to
3200.
LTS Sets the sensitivity of the label taken
Sensitivity sensor. Range is 0 to 14. Supported
Level when the Cutter or Label Dispenser
accessories are installed.
PM23c, PM43, and PM43c Mid-Range Printer User Manual
Default
Off
0
0
Fast
0
0