Table of Contents
Advertisement
About Cut-Off Printing
Caution: You must not use the cutter to cut through any kind of
adhesive, or other soft material, that may stick to the cutting parts
and render the cutter inoperable or even damage the electric motor.
Load Media for Cut-Off Printing
PM23c, PM43, and PM43c Mid-Range Printer User Manual
4 Turn the printhead lift lever clockwise to close the printhead. The
printer performs the action defined by the Head Down Action setting.
5 Press the Print button to advance the media.
6 Close the media cover.
In cut-off printing, each label is automatically cut from the media roll
immediately after the label is printed. You can print on non-adhesive,
continuous label stock. You can also use self-adhesive labels with a liner,
but you must cut only the liner.
The cutter module includes the top of form sensor. You can also install
the optional cutter tray accessory, which holds up to 20 labels or tickets.
After you load media, you need to configure the cutter and the feed adjust
settings. You may need to adjust the recommended values slightly
depending on your media type, supply method, and roll sizes, or because
of individual differences between printers.
Cut-off printing is supported by the PM43 and PM43c printers with the
cutter installed.
1 Open the media cover.
2 Turn the printhead lift lever counterclockwise to raise the printhead.
Chapter 2 – Set Up the Printer
33
Advertisement
Table of Contents
