Table of Contents
Advertisement
11. Turn the ignition switch ON (II), and measure
voltage.
Is there 8.5 V or less within the first 6
seconds
after turning the ignition switch
ON (II)?
Y E S —Faulty S R S indicator light circuit in the gauge
assembly; replace the S R S indicator circuit board in
the gauge assembly. •
N O - G o t o step 12.
12. Turn the ignition switch OFF.
13. Disconnect the dashboard wire harness 3P
connector C503 (A) from the S R S main harness.
14. Connect a voltmeter between the No. 1 terminal of
the dashboard wire harness 3P connector (C503)
and body ground.
D A S H B O A R D W I R E H A R N E S S
3 P C O N N E C T O R ( C 5 0 3 )
L
1
2
3
J
L
U
L_
J
Lb dJ
T e r m i n a l s i d e o f m a l e
t e r m i n a l s
15. Turn the ignition switch ON (II), and measure
voltage.
Is there 8.5 V or more within the first 6
seconds
after turning the ignition
switch
ON (II)?
Y E S - S h o r t to power in the BLU wire of the
dashboard wire harness; repair the harness. •
N O - G o t o step 16.
16. Turn the ignition switch OFF.
17. Disconnect the battery negative cable, and wait 3
minutes.
18. Disconnect the driver's and front passenger's
airbag connectors (A).
(cont'd)
23-243
Advertisement
Table of Contents
Troubleshooting
