Kenwood NEXEDGE NX-200 Function Reference page 421

15 GPS
15.1 GPS Functions
Configuration
If the transmission mode of the current channel is analog mode, GPS data including polling is automatically sent
Selected using the data zone channel (or GID) in analog mode. If the transmission mode for the current channel is NXDN
digital mode, GPS data including polling is automatically sent using the data zone channel in the NXDN digital mode.
Regardless of the transmission mode for the current channel, GPS data including polling is automatically sent using
Analog
the data zone channel (or GID) in analog mode.
Regardless of the transmission mode for the current channel, GPS data including polling is automatically sent using
NXDN
the data zone channel in the NXDN digital mode.
Note
• Configuration for GPS Report CH/GID does not apply to the transmission of GPS data using the Send the GPS Data and GPS
Combination.
• If a parameter other than "Selected" is selected for GPS Report CH/GID, the GTC Count is automatically disabled even if the GTC
Count has been configured, and GTC messages cannot be sent.
• If the transceiver receives a polling request, the GPS data is sent with the GPS Report CH/GID function disabled only for the first time.
If the GPS data is sent consecutively for the second or later time, the GPS data is automatically sent according to the configuration for
GPS Report CH/GID.
Configuration using KPG-111D/ DN
Configuring the GPS Report CH/GID (
GPS Report Back to Requested ID
GPS Report Back to Requested ID is the function that enables the receiving transceiver to send the GPS data to the ID of
the transceiver, which sends a GPS Polling Request, upon receipt of the following GPS Polling Requests.
• GPS Data Single Polling Request
• GPS Data Multiple Polling Request
• GPS Data Query Request
Configuration
Upon receipt of a GPS Polling Request, the transceiver sends the GPS data to the ID of the transceiver that sent the
Enabled
GPS Polling Request.
NXDN:
Upon receipt of a GPS Polling Request, the transceiver sends the GPS data to the ID configured for Base ID
(GPS).
If no Base ID (GPS) is configured, the GPS data is sent to the ID configured for Base ID. (Refer to
Disabled
page 160.)
FleetSync:
Upon receipt of a GPS Polling Request, the transceiver sends the GPS data to the FleetSync ID configured for
Base Fleet and Base ID. (Refer to
Configuration using KPG-111D/ DN
Configuring the GPS Report Back to Requested ID to be enabled or disabled (
FUNC (K)/Ver 4.00
Table 15-2 Configuration for GPS Report CH/GID
See FPRG 8.11.4 GPS Tab)
Table 15-3 Configuring GPS Report Back to Requested ID
The ID of the Target Transceiver (Base Fleet/ Base ID) on page
Description
Description
FPRG 8.11.4 GPS Tab)
See
CONTENTS
Base ID on
344.)
INDEX 387