Kenwood NEXEDGE NX-200 Function Reference page 336

12 FleetSync
12.1 Basic Configuration for FleetSync
Configuration using KPG-111D/ DN
Configuring the FleetSync II (
FleetSync Burst Noise Reduction
FleetSync Burst Noise Reduction mutes the incoming data burst tones when the transceiver receives FleetSync data.
When the transceiver receives an MSK data burst tone, the transceiver evaluates whether or not the tone is FleetSync
data. If it is FleetSync data, the transceiver mutes until it completes receiving FleetSync data. However, since it takes a
short period of time to recognize a tone as FleetSync data, the beginning of the tone may sound from the speaker for a
moment.
Receive
Signaling
Unmute
Mute
To receive the FleetSync data using BOT, the tone burst noise can be muted completely by configuring Mute Hold Time to
function at the same time. However, since Mute Hold Time is valid for all communications, if the time is configured overly
long, the beginning of the voice signal may also be muted on a channel that does not use the FleetSync functions. (Refer
to Muting the PTT ID Tone (PTT ID Mute) on page
Receive
Signaling
Unmute
Mute
Note
This function is valid only for MSK data in FleetSync.
Configuration using KPG-111D/ DN
Configuring the FleetSync Burst Noise Reduction to be enabled or disabled (
FUNC (K)/Ver 4.00
See FPRG 8.16.2 General 1 Tab)
Preamble Sync
Figure 12-1 Timing to Activate the FleetSync Burst Noise Reduction
307.)
Preamble Sync
Mute Hold Time
Figure 12-2 Timing to Activate Mute Hold Time
Carrier
MSK Data
Carrier
MSK Data
See FPRG 8.16.2 General 1 Tab)
CONTENTS INDEX 302