Kenwood NEXEDGE NX-200 Function Reference page 247

9 NXDN TRUNKING SYSTEM
9.5 Making an Individual Call (Transmission Trunked)
Restricting IDs for Which the Transceiver Can Initiate a Call (Unit ID Encode Block)
Unit ID Encode Block is the Unit ID range used to initiate a call.
A Unit ID with which a user is allowed to initiate a call can be restricted using KPG-111D/ DN. A user can use the Unit ID
stored in the Unit ID List even if it is outside the Unit ID Encode Block range.
The transceiver for which no Unit ID Encode Block is configured can initiate a call to all transceivers.
The transceiver disables the squelch and emits received audio when the transceiver receives an individual call. In this
case, the Unit ID of the transmitting transceiver appears on the receiving transceiver. The receiving transceiver can
respond to the transmitting transceiver by pressing the PTT switch. However, the transceiver cannot respond if initiating a
call to the Unit ID of the transmitting transceiver is restricted.
Note
• This function can be used with the Individual Call (Message Trunked (Enhanced)).
• In multiple systems, Unit ID Encode Block can be configured for each system.
Configuration using KPG-111D/ DN
• Configuring the Unit ID Encode Block (Single System) (
• Configuring the Unit ID Encode Block (Multiple Systems) (
Sending the Received Unit ID from the Communication Port (Unit ID Serial Output)
Unit ID Serial Output can be used to send the received Unit ID from the transceiver's communication port.
With the Unit ID Serial Output enabled, the dispatcher can monitor and control in real time transceivers that are
transmitting. Also, the Unit ID sent from the communication port can also be used for management of the call log.
Note
• To use Unit ID Serial Output, "Data" or "Data + GPS Data Output" must be assigned to the communication port of the transceiver.
• For an NXDN system, the same Unit ID may be sent multiple times for one transmission depending on the reception conditions of the
receiving party.
• If the transceiver receives a Group Call from a telephone, the transceiver will send an ID dedicated to the telephone (U65521
(0xFFF1)) from the communication port.
• This function can be used with the Individual Call (Message Trunked (Enhanced)).
Configuration using KPG-111D/ DN
Configuring the Unit ID Serial Output (
FUNC (K)/Ver 4.00
See FPRG 8.19.2 General 1 Tab)
See
See FPRG 8.10.6 Common Page 4 Tab)
FPRG 8.20.3 General Tab)
CONTENTS INDEX 213