Kenwood NEXEDGE NX-200 Function Reference page 292

10 ANALOG CONVENTIONAL SYSTEM
10.1 Initiating Voice Communications (Basic Transmission and Reception)
 If "Analog" is configured for Transmit Mode:
The transceiver transmits according to the configuration for Busy Channel Lockout (Analog).
 If "NXDN" is configured for Transmit Mode:
The transceiver transmits according to the configuration for Busy Channel Lockout (NXDN).
Also, while the Signaling Reset Timer or Auto Reset Timer is activated on a channel where "Mixed" is configured for
Channel Type, the transceiver transmits according to the configuration for Busy Channel Lockout in the same mode as
that of the received signal (Analog or NXDN). If the transceiver receives an analog signal, the transceiver will transmit
according to the configuration for Busy Channel Lockout (Analog). If the transceiver receives an NXDN signal, the
transceiver will transmit according to the configuration for Busy Channel Lockout (NXDN).
Note
• Refer to Avoiding Interference with Other Communications (Busy Channel Lockout (NXDN)) on page 116
behavior of the Busy Channel Lockout (NXDN).
• Busy Channel Lockout cannot be activated in Emergency Mode.
Configuration using KPG-111D/ DN
Configuring the Busy Channel Lockout (Analog) (
Preferentially Using a Channel Being Used by Other Parties (BCL Override)
BCL Override can be used to transmit on a busy channel even if Busy Channel Lockout is activated and transmission is
restricted. This function is used when a top priority transmission is required.
Operating the Transceiver
1
Press the PTT switch while transmission is restricted by Busy Channel Lockout.
2
Release the PTT switch, then press the
Busy Channel Lockout is temporarily disabled and the transceiver will start transmitting.
Note
This function is also activated while the transceiver is transmitting using VOX. For a transmission using VOX, Busy Channel Lockout
will temporarily be disabled and the transceiver can transmit if audio is input within 500 ms after the Warning Tone B starts sounding
from the transceiver.
Configuration using KPG-111D/ DN
Configuring the BCL Override to be enabled or disabled (
FUNC (K)/Ver 4.00
See FPRG 8.3.3 Page 1 Tab)
PTT switch again within 500 ms.
FPRG 8.2.12 BCL Override)
See
for details on the transceiver
CONTENTS INDEX 258