Kenwood NEXEDGE NX-200 Function Reference page 147

8 NXDN CONVENTIONAL SYSTEM
8.1 Initiating Voice Communications (Basic Transmission and Reception)
 Squelch Off Momentary key
1
Press and hold the
The " " icon appears. For NX-200S/ NX-300S, Key Beep A
sounds from the transceiver.
The Busy LED lights green if Busy LED is enabled.
The transceiver disables the RAN code and Optional Signaling
and unmutes the speaker upon detection of an NXDN frame.
White noise is audible if no carrier is received.
2
Release the Squelch Off Momentary
The " " icon disappears. For NX-200S/ NX-300S, Key Beep B
sounds from the transceiver.
A channel where RAN Decode or Optional Signaling is configured
resumes Signaling Squelch.
Note
• Pressing the Squelch Off key or the Squelch Off Momentary key while the Optional Signaling matches resets the matching state of
the Optional Signaling.
• If Squelch Off becomes enabled during the scan, the transceiver pauses scanning on a channel where the transceiver is scanning.
The transceiver does not resume scanning until Squelch Off is disabled.
• If Squelch Off is enabled on a channel where "Mixed" is configured for Channel Type, the transceiver mandatory unmutes the speaker.
White noise is audible if no carrier is present.
In this case, QT tone, DQT code, or RAM code will be disabled. If the transceiver receives an analog signal, the transceiver unmutes
the speaker only with a carrier. The transceiver unmutes the speaker when the transceiver receives a digital signal even if the received
RAN code does not match the RAN code preconfigured for the transceiver.
Configuration using KPG-111D/ DN
Assigning functions to the PF keys on the transceiver (
FUNC (K)/Ver 4.00
Squelch Off Momentary key.
key.
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
See FPRG 8.12 Key Assignment Window)
Mobile
Mobile
CONTENTS INDEX 113