Kenwood NEXEDGE NX-200 Function Reference page 218

8 NXDN CONVENTIONAL SYSTEM
8.17 Disabling the Transceiver Capability by Remote Control (Stun/ Kill)
GPS Position Display
GPS Position Display can be used to show the current location information of the own transceiver on the LCD.
Refer to 15.2 GPS Position Display on page 388
8.17 Disabling the Transceiver Capability by Remote Control (Stun/
Kill)
The transceiver capability can be disabled by wireless remote control. This function allows an system administrator to
remotely disable the transceiver, for instance, if the transceiver is lost.
The transceiver which has been disabled by this function can be enabled to be usable again by remote control from an
external device using radio communication.
In order to use this function, "Data" must be assigned to the communication port of the transceiver. (Refer to
Functions for COM Port on page
The transceiver will send the Remote Control Message using Individual Call if a PC sends the Remote Control
transmission command to the transceiver.
Following is the transceiver behavior when the transceiver receives a Remote Control Message.
Remote Control
Message
The transceiver is disabled if the transceiver receives the Remote Stun Message.
Whether to accept a Remote Stun Message when the transceiver receives the Remote Stun Message can
Remote Stun
be configured using KPG-111D/ DN.
If the transceiver receives the Remote Revive Message, the Stun state will be reset.
Remote Revive If the transceiver receives the Remote Revive Message, the Stun state will be reset.
If the transceiver receives the Remote Kill Message, the transceiver is disabled and all operations will be
prohibited. All configuration data of the transceiver is cleared, hence Stun state will not be reset even if the
transceiver receives the Remote Revive Message. However, the configuration data can be written to the
Remote Kill
transceiver using KPG-111D/ DN.
Also, whether to accept a Remote Kill Message when the transceiver receives the Remote Kill Message can
be configured using KPG-111D/ DN.
Note
• This function is applicable only when an individual call is initiated.
• The Stun state is identical to Stun for DTMF and FleetSync. (Refer to
(Stun/ Kill) on page 349, 14.3 Disabling the Transceiver Capability by Remote Control (Stun) on page
• The Stun state will be reset by Remote Revive even if the transceiver entered the Stun state by receiving a DTMF or FleetSync
signaling on a channel where "Mixed" is configured for Channel Type.
• The Stun state will be also reset if the transceiver receives a DTMF code (Stun Code + #) or FleetSync status (Status 92) on a channel
where "Mixed" is configured for Channel Type.
Configuration using KPG-111D/ DN
Configuring the Remote Stun/Kill to be enabled or disabled (
FUNC (K)/Ver 4.00
for details about GPS Position Display.
524.)
Table 8-20 Remote Control
Description
12.11 Disabling the Transceiver Capability by Remote Control
See FPRG 8.19.2 General 1 Tab)
CONTENTS
Available
371.)
INDEX 184