Gps Position Display; Disabling The Transceiver Capability By Remote Control (Stun/ Kill) - Kenwood NEXEDGE NX-200 Function Reference

12 FleetSync

12.11 Disabling the Transceiver Capability by Remote Control (Stun/ Kill)

GPS Position Display

GPS Position Display can be used to show the current location information of the own transceiver on the LCD.
Refer to 15.2 GPS Position Display on page 388
12.11 Disabling the Transceiver Capability by Remote Control (Stun/
Kill)
Stun/ Kill is the function for an administrator to remotely disable the transceiver by using a Remote Stun/ Kill status, for
instance, if the transceiver is stolen. (Refer to
Following is the transceiver behavior when the transceiver receives a Remote Stun/ Kill Status.
Status
The transceiver becomes unable to transmit when the transceiver receives the Remote Stun status (Status 90).
The transceiver becomes unable to transmit and receive when the transceiver receives the Remote Stun status
Remote Stun (Status 91).
The Stun state is reset when the transceiver receives the Remote Revive status (Status 92).
Whether to accept reception of the Remote Stun status can be configured by using KPG-111D/ DN.
Remote Revive The Stun state is reset when the transceiver receives the Remote Revive status (Status 92).
The transceiver is disabled and all operations will be prohibited when the transceiver receives the Remote Kill status
(Status 87).
All configuration data of the transceiver is cleared; hence the Stun state will not be reset even if the transceiver
Remote Kill
receives the Remote Revive status (Status 92). However, the configuration data can be written to the transceiver
using KPG-111D/ DN.
Whether to accept reception of the Remote Kill status can be configured by using KPG-111D/ DN.
Note
The Stun state is identical to Stun for NXDN and DTMF. Also, the Stun state will reset upon receiving an NXDN Remote Revive
Message or DTMF Revive Code (Stun Code + #) even if the transceiver receives the Remote Stun status and enters the Stun state.
(Refer to 8.17 Disabling the Transceiver Capability by Remote Control (Stun/ Kill) on page
Capability by Remote Control (Stun) on page
Configuration using KPG-111D/ DN
Configuring the Stun/Kill Status Validation (
FUNC (K)/Ver 4.00
for details about GPS Position Display.
Reserved Statuses of Status Messages on page
Table 12-21 Remote Stun/ Kill Statuses
Description
371.)
FPRG 8.16.2 General 1 Tab)
See
331.)
184, 14.3 Disabling the Transceiver
CONTENTS INDEX 349