Kenwood NEXEDGE NX-200 Function Reference page 162

8 NXDN CONVENTIONAL SYSTEM
8.5 Making an Individual Call
3
Press the PTT switch to initiate a Voice Call.
In order to initiate a Paging Call, the Side 2 key (NX-200/
NX-210/ NX-300/ NX-410/ NX-411) or the Square key (Mobile)
needs to be pressed.
In order to enter a Status Message or Short Message, the Menu
([ ]) or [*] key needs to be pressed. (Only if the transceiver
enters Individual Call Mode by a user pressing the Individual +
Status (NXDN) or Individual + SDM (NXDN) key or selecting
Individual + Status (NXDN) or Individual + SDM (NXDN) by a user
pressing the Menu key) (Refer to
Status Message (Status Call) on page
 Initiating an Individual Call using Manual Dialing
To initiate an Individual Call using Manual Dialing, Manual Dialing must be enabled using KPG-111D/ DN.
1
Press the Individual
The transceiver enters Individual Call Mode and then the Unit ID
List selection display will appear.
The following operations are identical even if the transceiver
enters Individual Call Mode by a user pressing the Menu key or
using the keypad.
2
Press and hold the
The Unit ID entry display appears.
Pressing the Left key will also show the entry display of the Unit ID.
FUNC (K)/Ver 4.00
8.9 Sending and Receiving a
150.)
(NXDN), Individual + Status
Menu ([ ]) or [*] key.
(NXDN), or Individual + SDM (NXDN)
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
NX-200/ NX-210/ NX-300/ NX-410/ NX-411
CONTENTS
key.
Mobile
Mobile
INDEX 128