Kenwood NEXEDGE NX-200 Function Reference page 192

8 NXDN CONVENTIONAL SYSTEM
8.9 Sending and Receiving a Status Message (Status Call)
Status List
Status Message must be preconfigured in the transceiver using KPG-111D/ DN prior to the transmission. A maximum of
207 statuses can be configured in the Status List.
Configuration
The Status number can be configured. The Status Number can be configured by using a number between 1
Status
and 207.
The Status number can be configured. It is not easy to recognize the meaning of a status only by viewing a
status number. In this case, a user can link the status number to a short message; hence, it can be easily
understood. A maximum of 16 characters can be configured.
Status Name
If the status number is configured in the Status List, the Status Name appears when the transceiver receives
a Status Message. If the transceiver receives a status that is not configured in the Status List, the status
number appears on the transceiver display.
The transmission to the receiving party can be enabled or disabled.
The status for which "Yes" is configured for Transmit Inhibit does not appear on the Status selection display
Transmit Inhibit
in Status Mode. In this case, a user cannot select a status for which "Yes" is configured for Transmit Inhibit in
Status Mode.
The type of tone sounding from the transceiver can be configured for a received status number from the
Alert Tone
status numbers registered in the Status List.
Configuration using KPG-111D/ DN
Configuring the Status List (
Special Status
Special Status is a function used to prevent a user from sending the status number 226 erroneously.
Status 226 is a status to disable Emergency Mode.
Note
This function is unavailable for NX-200S/ NX-300S.
Configuration using KPG-111D/ DN
Configuring the Special Status (
Status Message Stack
Status Message Stack is the function to store a Status Message in the stack memory. A maximum of 15 Status Messages
can be stored in the stack memory.
If a message is stored, the "
enters Stack Mode. (Refer to
FUNC (K)/Ver 4.00
Table 8-14 Status List
FPRG 8.19.8 Status List Tab)
See
See FPRG 8.19.2 General 1 Tab)
" icon blinks. In this case, a user can read the stored Status Message if the transceiver
3.7 Viewing the Receive History (Stack) on page
Description
38.)
CONTENTS INDEX 158