Kenwood NEXEDGE NX-200 Function Reference page 277

9 NXDN TRUNKING SYSTEM
9.17 Adding a Group ID by Remote Control (Remote Group Add)
Transceiver's Behavior when Using the Regroup ID
Following are the transceiver's behavior when using the added Regroup ID.
• The added Regroup ID will be retained even after the transceiver is turned OFF.
• The added Regroup ID can be used even if the transceiver migrates to another site.
• If the Regroup ID is selected while "CH/GID Number" is configured for the Sub-LCD Display, "0" appears on the
transceiver sub-display. (Refer to
• A Rollover Tone sounds from the transceiver if the transceiver migrates to the Regroup ID by a user operating the
Selector (Portable only) or PF key where "CH/GID Up/Down" is assigned.
• Entering a value of "0" for a GID No. in Channel Entry Mode enables the GID to be changed to a Regroup ID.
(Refer to Changing the Channel or GID by Specifying the Number (Channel Entry) on page
• The Regroup ID cannot be configured as a Direct GID by a user pressing the Direct CH/GID Select key. (Refer to
Direct CH/GID on page
• The Regroup ID cannot be configured as a Home GID by a user pressing the Home CH/GID Select key. (Refer to
Home CH/GID on page
• A Key-entry Error Tone sounds from the transceiver and the transceiver does not respond at all even by a user
pressing the Scan Delete/Add key while the Regroup ID is selected.
• If a Regroup ID is configured for the Revert CH/GID while "Selected" is configured for Revert CH/GID, the Revert
CH/GID will be changed to the lowest GID configured in an NXDN Trunking Zone when the transceiver receives
the message requesting to reset the change of the remote group. (Refer to
• For Portable, if a GID other than the Regroup ID is selected by a user rotating the Selector while "CH/GID Select"
is assigned to the Selector, the Regroup ID cannot be selected using the Selector later. However, the Regroup
ID can be selected by a user using the CH/GID Up and CH/GID Down keys.
• During a scan, if the transceiver receives a message requesting to change the remote group where the change of
Group ID is enabled, the scan will continue. During the scan, if the transceiver receives a message requesting to
change the remote group where changes of the Group ID is not allowed, the scan will pause. The transceiver
transmits using the Regroup ID when the transceiver transmits in the above conditions. Also, the transceiver
resumes the scan when the transceiver receives the message requesting to reset the change of the remote group
in this state.
• If the transceiver receives the message requesting to change the remote group where the change of the Group ID
is enabled, the conditions to resume a scan are satisfied and the transceiver will resume the scan, while the scan
is temporarily paused if the conditions to resume the scan are not satisfied because of the lack of GIDs to scan. If
the transceiver receives the message requesting to reset the change of the remote group in this state, the
conditions to resume the scan are not satisfied again and the scan will pause.
• In Emergency mode, the transceiver cannot send and receive the message requesting to change the remote
group or to reset the change of the remote group.
FUNC (K)/Ver 4.00
Sub-LCD Display on page
35.)
32.)
81.)
Revert CH/GID on page
CONTENTS
29.)
453.)
INDEX 243