Mitsubishi Electric MELSEC iQ-R Series User Manual page 477

[Da.15] Condition target
Set the condition target as required for each control.
Setting value
01H: Device X
02H: Device Y
03H: Buffer memory (1-word)
04H: Buffer memory (2-word)
05H: Positioning data No.
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 406 Positioning data (Block start data)
[Da.16] Condition operator
Set the condition operator as required for "[Da.15] Condition target".
[Da.15] Condition target
01H: Device X
02H: Device Y
03H: Buffer memory (1-word)
04H: Buffer memory (2-word)
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 406 Positioning data (Block start data)
Downloaded from ManualsNet.com
Setting details
Set the state (ON/OFF) of an I/O signal as a condition.
Set the value stored in the buffer memory as a condition.
03H: The target buffer memory is "1-word (16 bits)"
04H: The target buffer memory is "2-word (32 bits)"
Select only for "simultaneous start".
Setting value
07H: DEV = ON
08H: DEV = OFF
01H: ** = P1
02H: **  P1
03H: **  P1
04H: **  P1
05H: P1  **  P2
06H: **  P1, P2  **
search engine
Setting details
When the state (ON/OFF) of an I/O signal is set as a condition, select ON or OFF as the
trigger.
Select how to use the value (**) in the buffer memory as a part of the condition.
12 DATA USED FOR POSITIONING CONTROL
475
12.6 Condition Data
12