Mitsubishi Electric MELSEC iQ-R Series User Manual page 414

[Pr.141] IP address
Specify the IP address.
Assign 1 [byte] each to octets 1 to 4.
b31 b16
1st octet 2nd octet 3rd octet 4th octet
Ex.
For 192.168.3.1
Setting value: HC0A80301
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 397 Servo network composition parameters
[Pr.142] Multidrop number
When one station includes multiple logic axes, such as a multi-axis drive unit, specify the number to distinguish the logic axes.
Specify 0 when using a single axis servo amplifier.
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 397 Servo network composition parameters
12 DATA USED FOR POSITIONING CONTROL
412
12.3 Basic Setting
Downloaded from ManualsNet.com
b15 b0
• When using the amplifier as an actual servo amplifier, always set an IP address. Axis control cannot be
performed when it is set to the default value of "0".
• For this parameter, the value set in the flash ROM of the Motion module becomes valid when the power is
turned ON or the CPU module is reset. The value is not fetched by turning the PLC READY signal [Y0] ON
from OFF. Therefore, write to the flash ROM after setting the value in the buffer memory to change. . (The
value must be fixed when turning ON the power or resetting the CPU module.)
• For this parameter, the value set in the flash ROM of the Motion module becomes valid when the power is
turned ON or the CPU module is reset. The value is not fetched by turning the PLC READY signal [Y0] ON
from OFF. Therefore, write to the flash ROM after setting the value in the buffer memory to change. . (The
value must be fixed when turning ON the power or resetting the CPU module.)
search engine